问题：
What is the connection to get LTC into the WVR6000/WVR7000 series?
答案：
An LTC is input through the 15-pin Remote connector on the rear panel. To input an LTC signal, you need to construct a cable. This cable has four wires from the Remote connector, two to an RCA connector and two to a BNC.
Pin 7 of the Remote connector is connected to the center pin of the RCA connector, and pin 6 is connected to the shield of the RCA connector.
Pin 8 of the Remote connector is connected to the center pin of the BNC and pin 6 goes to the shield of the BNC.
LTC Signal Amplitude Range , 0.2 V p-p to 5.0 V p-p balanced differential or single-ended.
NOTE : Apply a signal to only one connector at a time.
此常见问题适用于：
无产品系列
产品：
常见问题 ID 61216
查看所有常见问题 »