Q: I'd like to record and save several waveforms in quick succession, e.g. up to five waveforms per second. I would like to analyse the waveforms later on a computer. How can I do this?
I currently have a Tektronix DPO 2024b. I have been manually saving single waveforms to a USB drive. This is too slow for what I want to do.
Are there some software extensions which can do what I want if I connect my computer to the oscilloscope? Or a particular model of oscilloscope that is better suited to this than the DPO 2024b model I currently have? Would I need to write any code for this myself (I have zero experience in oscilloscope programming).
I have found "TekScope Utility" by searching through this forum on similar topics. I haven't got this working yet, but am playing around with it.
A: It appears what you want is to transfer the waveform over the connection.
To do this, you should use the following sequence:
scope.write('CURVE?')
data = scope.read_raw()
"CURVE?" outputs the waveform data and the following line reads that into an array you can then process and/or save as you wish.
the DPO2000 series is NOT fast enough to produce waveforms out the remote interface (or even to a local USB drive) at 5 waveforms per second. This scope will likely produce somewhere between 1-3 per second. The reason for this has nothing to do with binary versus .csv saving format, but rather that the scope isn't quick enough to perform single sequence acquisitions and then spit out the data via CURVE? query that fast. You might be able to achieve these rates on the new 2 Series MSO scopes (5/6 Series can definitely do these rates and higher with TekHSI).
联系我们
与泰克代表实时聊天。 工作时间:上午 9:00 - 下午 5:00(太平洋标准时间)。
电话
致电我们
工作时间:上午9:00-下午5:00(太平洋标准时间)
下载
下载手册、产品技术资料、软件等:
反馈
